Skip to content

01 ldo_breakout

Reference: AMS1117-3.3 typical application. First built from memory of the datasheet; read on 2026-11-14 (see below).

Stresses: nothing; it exists to prove the loop from board.py to Gerbers.

What broke - ERC: 16 library warnings: the project named libraries it did not carry. - Schematic parity: /VIN on the schematic vs VIN on the board. - kicad-tools' own router routed one net and overwrote .kicad_pro. - Freerouting necked a track to 0.187 mm against a 0.2 mm minimum.

Tool changes - Vendor the used symbols and footprints into <board>/libs, trimmed. - Global labels on every pin instead of local ones. - Route through Freerouting (DSN out, SES in); rewrite .kicad_pro after kct. - Widen any segment under min_track_width after import.

Left open: none worth recording.

Second pass: the datasheet, read

The datasheet asks for 22 uF solid tantalum on the output ("will ensure stability for all operating conditions"): the regulator relies on the output capacitor's series resistance, and the board had a ceramic. C2 is now a 22 uF tantalum in EIA-3528; the board was regenerated and passes the gate. The "10 uF in" was a misremembering of the adjust-pin bypass in Figure 1; the datasheet shows no input capacitor, so C1 stays as a choice. SOT-223 dissipation is capped at 1.2 W, about 0.7 A from 5 V.